repetier and SAV MKI

oscar2015

Hi everyone.

I am thinking to buy a 3D printer and I would like to know if REPETIER is compatible with the SAV MKI board.

Thanks in advance.

Repetier

It does not have a matching pins.h. No one send me one and I don't have that board to do the testing myself.

But it contains supported components, so compiling it is just copying a printrboard config parts in pins.h and update pin numbers.

That said, it has one big drawback - only 128K flash. Firmwares are getting better and better but also grow in size. With all features enabled it will break the 128kb limit.

boelle

i got it to work.... sort of...

i had to disable SD card support or else i could not get in contact with the board

boelle

i hijacked motherboard 8 which uses the same chip and just adjusted the pin numbers

REMEMBER... SD Card does not work... not had the time to figure why

/****************************************************************************************

* Teensylu 0.7 pin assingments (ATMEGA90USB)

* Requires the Teensyduino software with Teensy2.0++ selected in arduino IDE!

****************************************************************************************/

#if MOTHERBOARD == 8

#define KNOWN_BOARD 1

#define ORIG_X_STEP_PIN         28

#define ORIG_X_DIR_PIN          29

#define ORIG_X_ENABLE_PIN       19

#define ORIG_X_MIN_PIN          25

#define ORIG_X_MAX_PIN          -1

#define ORIG_Y_STEP_PIN         30

#define ORIG_Y_DIR_PIN          31

#define ORIG_Y_ENABLE_PIN       18

#define ORIG_Y_MIN_PIN          26

#define ORIG_Y_MAX_PIN          -1

#define ORIG_Z_STEP_PIN         32

#define ORIG_Z_DIR_PIN          33

#define ORIG_Z_ENABLE_PIN       17

#define ORIG_Z_MIN_PIN          -1

#define ORIG_Z_MAX_PIN          27

#define ORIG_E0_STEP_PIN         34

#define ORIG_E0_DIR_PIN          35

#define ORIG_E0_ENABLE_PIN       13

#define TEMP_0_PIN          7 // Extruder - ANALOG PIN NUMBER!

#define TEMP_1_PIN          6 // Bed - ANALOG PIN NUMBER!

#define HEATER_0_PIN       15 // Extruder

#define HEATER_1_PIN       14 // bed

#define HEATER_2_PIN   -1

#define TEMP_2_PIN     -1

#define SDPOWER            -1

#define SDSS                20

#define LED_PIN            -1

#define ORIG_FAN_PIN            16 // Fan

#define ORIG_PS_ON_PIN          -1

#define E0_PINS ORIG_E0_STEP_PIN,ORIG_E0_DIR_PIN,ORIG_E0_ENABLE_PIN,

#define E1_PINS

#if !SDSUPPORT

// these pins are defined in the SD library if building with SD support

#define SCK_PIN          21

#define MISO_PIN         23

#define MOSI_PIN         22

#endif

#endif

boelle

Repetier any clue why SD card does not work?

Repetier

Not really. that is one of these problems that can only be solved locally. Normally it is just a wrong pin definition that is active at the end.