signal exchange with an Arduino DUE / YUN-Shield

Bricoloage

My intention is to link the Repetier-Server with an Arduino DUE / YUN-Shield to send a flag which is indicating the END of the printing process (Repetier-Server is running on a Raspberry-Pi). The Arduino unit is controlling an internal heating subsystem of the printer to heat up the processing box inside. The heating is an experimental auxillary equipment, which is recently on/off-switched by hand, so that the aime is to stop the heating after finishing the printing job automatically. Any ideas to pick-up such a flag from Repetier-Server?

Repetier

Check online docs for lua modules. These can watch events per printer and more and can add any logic you want.

Bricoloage

Thanks. But the information is a bit stub. The question is how and where to pick up the flag "printing end" exactly and how to loop it out?

Repetier

You need to listen to events. See https://www.repetier-server.com/manuals/programming/API/index.html at the end for events available.

jobFinished (0.60.2)

Payload: {start:unixTime,duration:seconds,end:unixTime,lines:linesOfJob}

Gets send after a normal job has finished.

jobKilled (0.60.2)

Payload: {start:unixTime,duration:seconds,end:unixTime,lines:linesOfJob}

Gets send after a normal job has been killed.

jobStarted (0.60.2)

Payload: {start:unixTime}

Gets send after a normal job has been started.

are the one you might be interested in.

Bricoloage

Many thanks for the moment, I think that this will help!