Can i initiate auto bed leveling remotely?

Mariskay

Hey there, CR10S, Marlin firmware, any way to initiate AutoBedLeveling with probe remotely from Repetier Server www? Thanks

Repetier

Yes, just send the gcode over the console. I think marlin uses G32 for autoleveling.

Mariskay

Ah, okay, G32 and storing the probe matrix, do you know which code does that after bed has been auto-leveled?

Mariskay

Would be great if i could create custom buttons and put any G-code script under them in Repetier Server GUI

Repetier

You can. Go to printer settings->G-Codes and add a quick command. That is available in control and manual control  in the dropdown for gcode commands then.

For exact definition of G32 please read marlin manual.

Mariskay

Thanks, will look into it!

MartinH

Marlin firmware uses G29 for auto level,  G32 is 'repetier'' firmware

https://reprap.org/wiki/G-code#G29:_Detailed_Z-Probe