New guy need help! :D
Hey guys, recently built a 3D printer Delta K280. Using Repitier software. Read alot about configuring my EEPROM firmware. I pretty have the gist of everything locked and loaded. Last step for me before my first print is to properly fix the bed height. Learned that I can't activate bed distortion via G33 unless activating it via configuration.h file. Went to: https://www.repetier.com to download my file for my printer settings. After I downloaded the file, what do I do? Do I open the file via repetier host or import the file via import command via EEPROM config. Someone tell this noob what they're suppose to do.
Cheers.
Vaughn
Cheers.
Vaughn
Comments
I inputed all the specifics of my printer. I followed the installation instructions via: http://www.reprapmall.com/index.php?route=pavblog/blog&id=40 & https://www.repetier.com/tutorials/
I'm completely new and need a general explanation of how to upload the firmware to the printer.
Steps I took were:
Built printer,
Installed Repetier-Host
Configured printer settings
Configured EEPROM settings (while running checklist)
So what do I do from here to start my first print? How do I upload the configure.h file I downloaded? Detailed step by step explanation would be awesome!
https://www.repetier.com/documentation/repetier-firmware/