Z seam using both slic3r and prusa edition
not sure if ive altered a setting wrong but i cant find one that alters the problem i am getting a gap at the point of the start and end of a layer ,
when i started using prusa edition in December i had no seam lines in my part both on the pc display in host and also on the actual print but now i do .
if i slice with cura in host or actually in the prusa edition software the seam disappears hope someone can help
when i started using prusa edition in December i had no seam lines in my part both on the pc display in host and also on the actual print but now i do .
if i slice with cura in host or actually in the prusa edition software the seam disappears hope someone can help