Gcode Screen Display
Raspberry Pi 2 and .51 chrome browser and seemecnc rostock max v2
Everything works very well but the display of the gcode in either the viewer or the printing display. I only ever get the upper right hand quarter of the object printed on the screen.
Has anyone got any ideas?
Everything works very well but the display of the gcode in either the viewer or the printing display. I only ever get the upper right hand quarter of the object printed on the screen.
Has anyone got any ideas?
Comments
Everything works fine as well.
However, I only get the top left quarter of the model displayed during prints on the screen in 3D view of the manual control tab.
It prints fine, just does not display the entire print.
If we can combine both of our problems we could at least see the top half of the prints displayed ;-)) Now then we need to fined two with the bottom quarters.
Honestly, it would be nice if someone could point to a solution. It's not a show stopper, but it would enhance the experience a little more if it displayed properly.
Thanks in advance.