›

Printing job won't start

Goose83Goose83
in Repetier-Server
I have installed repetier server on a raspberry pi3 and while everything else works, when starting a printing job, the printer homes all axis and then waits/standing still.
The gcode does not contain M109/M190. 

What to do?

Comments

  • RepetierRepetier
    Please go to console and enable ack/commands to see what is going on. So you also see at which commands it could hang and why. I assume the job is not marked finished.

    Also make sure to use 0.86.2 and not older versions where some had deadlocks.
Sign In or Register to comment.