Extruder runs off bed

CadRat · February 2015

I am a newbie here so be patient:)

I just built a Folger Prusa i3. Everything is up and running now. I installed Repetier Host 1.0.6 and Slicr3. My bed is leveled and zeroed on all axis. After the bed and the nozzle get up to temp and I start the print, The nozzle lifts and runs completely off the back corner of the bed no matter if I use Cura or Slicr3. It just does not go to center and start printing. PLEASE PLEASE HELP! Over 20 hours and aint got much hair left... Thanks CadRat

RepetierSupport · February 2015

Check the sent gcodes. One of it yould be the move you do not like.

Extruder runs off bed

Comments