V2.05 Can't generate support even "Everywhere"

jessierow · September 2017

Image: http://forum.repetier.com/uploads/editor/f2/5h0u3hk04fd3.jpg

Image: http://forum.repetier.com/uploads/editor/kc/3ljxz41fz2kg.jpg

No matter what overhang angel I set (from 0-90), no support is generated at all possible hole.
I used repetier host (cura engine) quite a lot in these 2 years but have never seen that.
Anything wrong in setting?

Repetier · September 2017

Maybe bad settings in cura settings for support. Tested with 60°, 15% fill, 0.7 xy distance and 0.15 z distance worked for me.

V2.05 Can't generate support even "Everywhere"

Comments