repetiorHost 2.0.1 didn't show the layer from G-code under Ubuntu 16.04

svd71

Hallo everybody. I have follows configuration:
OS:
Linux svdnb2l 4.4.0-79-generic #100-Ubuntu SMP Wed May 17 19:58:14 UTC 2017 x86_64 x86_64 x86_64 GNU/Linux

Mono:
Mono JIT compiler version 4.2.1 (Debian 4.2.1.102+dfsg2-7ubuntu4)
Copyright (C) 2002-2014 Novell, Inc, Xamarin Inc and Contributors. www.mono-project.com
    TLS:           __thread
    SIGSEGV:       altstack
    Notifications: epoll
    Architecture:  amd64
    Disabled:      none
    Misc:          softdebug
    LLVM:          supported, not enabled.
    GC:            sgen


 I did make the g-code from the Eagle CAD, how it explained this document, but the isometric picture didn't showed. I have tested it with Windows version - it showed fine.

Repetier

Since it is no extrusion it is shown as travel moves. Check the toolbar - there are 2 icons - one to enable filament visualization and one to show travel moves. I guess travel moves is just disabled.

svd71

Yes! It work! Thank you very much!