ETE Time is off

Im trying to figure out why my ETE Is so off. i have my feedrate override at 100% so thats not it. but i did a print last night that was suppose to take 14hr and it was done in 8, now i dont mind that, just wish i can narrow down the actual time so i can plan my prints.

Comments

  • Host does simple computation and adds a fixed percentage you have set in printer settings to that time. I think that addition is simply too much for your slicer setting. 

    For better prediction use Repetier-Server as print server, even if you use the host. Host will still show host estimates but in server you see server estimates and if you have configured acceleration etc correctly in server. Server simulates firmware with these data so if configured correctly it matches much better.
Sign In or Register to comment.