Webcam snapshot and printed information for Print-Report
My 3D printers contain automated bed emptying solutions. The beds are being emptied after a print is completed and is initiated from the END_PRINT macro. I am relying on my print reports to verify whether a print is successful or failed. Unfortunately the webcam snapshot in the print report always shows an empty bed as the snapshot is taken after the beds are being emptied. Is there a way to call out the function for these snapshots which I can put in my END_PRINT macro? Or is there another way to solve this?
My second question is, is there a way to customize the information that is listed on the print reports? For example, I don't really care about the achieved temperature precision and the long text below it. I also would like to customize the Event Notes at the bottom to list more user understandable error messages, like: Emergency pressed, Filament runout, Filament Jam, etc.
Best regards, Faris (Felix / LFT / Insolution)
My second question is, is there a way to customize the information that is listed on the print reports? For example, I don't really care about the achieved temperature precision and the long text below it. I also would like to customize the Event Notes at the bottom to list more user understandable error messages, like: Emergency pressed, Filament runout, Filament Jam, etc.
Best regards, Faris (Felix / LFT / Insolution)