› ›

Manual control 'bed' GUI not working

dewrtdewrt
in Bug Reports
Hi!

Been using RepetierServer for a little while now. Initially, the manual control slider GUI worked just fine, but from a point maybe a month or two ago, it just completely stopped working.
I can control the printer just fine with the movement control buttons, but the sliders do not work anymore.
Tried this on multiple printers, same results.
https://imgur.com/a/nMfu7Ef

Comments

  • RepetierRepetier
    Yes, it is a bug. Fixed in 1.4.18 coming next week. You can still use the move buttons in the side bar until then.
  • dewrtdewrt
    Brill, just wanted to confirm that it was known about.

    Thanks!
Sign In or Register to comment.