Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Repetier-Firmware
Setting Esteps for specific extruder
MKS Gen-2z v1.1/Ramps 1.4/A4988 on Prusa i3 with LCD2004A display
Motor Driver (name)
bed cooling
Active low stepper pulse
Homing and pure z motion is smooth but x/y is very jerky
Extruder Reverses Filament Prior to Print
Radds + raps128 Delta optimal advance settings
.92.8 Crashes hard
HELP!!, Error:Apos y steps
Set X/Y origin correctly with Firmware
Print Quality Test Generator
SD init fail using RepRapDiscount Full Graphic Smart Controller in Repetier 0.91/0.92
HELP !! Auto-Level, Z Homing, CobbleBot = Total Headache!!!
Z speed limits ignored
what thermistor type number to pick?
Decoupling or Something Else
Two extruders w/PID control and two part fans - Possible on RAMPS 1.4?
Motor Steps/mm configuration
Erase eeprom
« Previous Page
Next Page »
Privacy Policy
|
About Us
