Motor Control

Z-Axis Erratic Behaviour
mks base v1.2 board with Y axis not working.
All extruders working at the same time
"Could not activate z" after trying to callibrate Z=0 and probe height on Sparkcube V1.1XL
Z Endsstop crashes into bed after pullup in right direction.
Z-Achse Configurieren
S-Curve Acceleration or Trapezoidal Acceleration
Motor is stuck and only humms loudly, will not home or move. M114/Move commands returns crazy value
G28 retracts too fast
Is there a way to simulate the homed condition without motors and limits installed?
Can I add a feature to the firmware to send a message when motors have stopped?
ticking sounds
Durch Installation am haben sich beim Extruder Steps/mm verändert
CoreXY moved endstops 24.5mm on X and Y Min endstop bounce and Jitter
setting up tmc2209 drivers in DEV2
Can anyone explain this Makergear M2 Z-axis movement.
The speed, acceleration and dimensions of the print area are not recorded in EPROM
Mirrored motor on arduino mega and ramps to buildup a MPCNC
motors just vibrate
All motors energized but not moving at all