Just installed a new J end mount
for My e3d hot end this cause a bit of an issue as the new part cooling blowers
are almost an inch in front of the end stops (i.e. never gets close) Moved
X and Y end stops farther out by 24.5mm back and over (left side and rear) normally
homing is XYZ on this CoreXY
Now when I manually Home X or Y it comes up to the
end stop and bounces, then jitters
if I move manually before power on set the
carriage into the x and y stop are on and lighted home and it goes
up to Z end stop
if I move, say 190 X and Y and 100 down on Z and
if I choose to go home it goes to the end stop Y and then X jitters from left
end (hard to tell if it actually get to Y but X moves right instead of left (end
stop to about 100 and jitters never goes left to the X end stop, forcing me to
do a hard power off
I checked the end stop with m119 all low and
go high when Held, so the end stops work and the motors X and Y move when
commanded with g1 x 190 Etc.
Wondering if there is something simple I missed
when moving to the new end stop. Are they not static position? Do I need home X and
Y manually and save the new home positions? (acts like it wants to go farther than the end
stop? since the new zero is 24.5mm away for x and y)
Nothing has been touched in the Config file,
only moved physically the X & Y end stops 24.5mm, very strange. Any help or suggestions are welcome. Certain
I am over thinking something?
Repetier 0,92 CoreXY 600x600x900 3 z motors I X 1
Y and 6 extruders ramps 1.4 (Soon changing MKS L version 2)
this had been working now for 5 years until this endstop changes.
Recoush
