Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Extruder & Bed
Heater seems decoupled com thermistor
Filament out sensor
Probleme Aufheizen Extruder 2
Heater decoupled + PID autotune
Problems with dual extrusion using a wipe tower
Z-Probe - Activating z-probe would lead to forbidden xy position - WHY??
while doing G32, it press on the bed at some points.
Z-probe hight- software indiferent to changes
After PID tuning extruder still overshoots on temp.
Setting extruder temperature more precisely
Mirrored Extruder spins with Z on Home and Raise
Putting PID info into arduino sketch
Moving probe Z-up is vey slow
Extruder Offset in Deltas
Hotend is always 13°C to Hot
zprobe Activity
I installed a EV63D extruder clone, now it hangs too low on my Davinci 1.0 using repetier 0.92
Bed leveling and homing w Z-min
Installed a long extruder, now it hangs too low on my Davinci 1.0. How do I lower the bed home?
Extruder dead-time temperature occasionally out of control
« Previous Page
Next Page »
Privacy Policy
|
About Us
