Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Extruder & Bed
Heater heat up but cannot reach to the temperature (2 to 5 degree below)
Suddenly Z probing does not work anymore
Colido Compact Extruder Head Temperature
extruder direction reversed
Rostock Max: HE280 accelerometer z probe & filament runout sensors
Temperature dips
Temperature in Repetier Host different from the internal temperature of the nozzle
Move cold extruder
Use Heated Bed as Filament Dryer
error:One heater seems decoupled from thermistor - disabling all for safety! Recv
max extrusion length
wich settings for E3D PT1000 temp Sensor
Extruder overhoots while heating up
BLTouch version compatibility
Cannot set firmware to control HEATER_2_PIN as extruder cooling
Autotuned Extruder Consistently Under Temp
Auto Pid tuning
E3D Cyclops with Repetier Configuration
problems with the offset of the extruder
I got stuck in configuring a dual x carriage setup
« Previous Page
Next Page »
Privacy Policy
|
About Us
