Hi there.  Sorry for having to make this thread but I've searched high and low for a solution and wasted a lot of time trying to figure it out but I'm totally stumped (and a bit frustrated).  I appre…

Mono serial library does only support ANSI baud rates. 250000 baud is no such baud rate. As a solution we call a C++ softwware SetBaudraute after connecting to change it using that software (sources …

Really confusing, so can not say that is that is the problem. Host has home position in settings so that is what you see if it fails and does not report position.

No, but here a sample that makes a led blink and shuts down pi on button press

Hi 

Repetier said:

Hi!

seit dem ich das angewedet habe:

Hi,  I have been trying to update Repetier Host following an upgrade of my operating systems to High Serria.  The upgrade function from 1.1.0 came up with an error message previously discussed on the…

Looks like you did not understand me since the error is what you already thought:

Repetier said:

I have a compiler error with 1.0.4dev (Arduino 1.8.9 - Board Mega 2560) with    "#define EEPROM_MODE 1"

The problem lies in how server handles firmware wish to disconnect. Well it does and then it reconnects but klipper is in error state as it does not reset. I have modified this for next release. For …

Hi all,

First use homing sequence with preheat and set min extruder temperature 0. Then you can define where to probe.

I have installed an inductive probe LJ12A3-4-Z/BX on a P3Steel Toolson MK2.

Kann man den freien Ram beim Kompilieren oder während des Betriebs irgendwie auslesen?

cosmith71 said:

I'm trying to get this to work.  I'm getting the following error:

I just downloaded  "Repetier-Firmware 1.0.x with Configuration Tool" and am trying to compile it for Arduino Due in the Arduino 1.83 environment on a Windows 7 machine.