-
Repetier configuration tool and Full Graphic Smart Controller
by MShievitz ·#endif -
Motor control in Rep 9.23
by MShievitz ·(PULLEY_DIAMETER * 3.1415927)<br />#endif<br />/** \brief Steps per rotation of stepper motor */<br />#define STEPS_PER_ROTATION 200<br />/** \brief Micro stepping rate of X, -
Wait for Cooling Bed?
by Repetier ·#endif -
add m-codes
by RAyWB ·#endif -
G0 rapid move
by galmiklos ·#endif -
Printer communication problems
by Repetier ·#endif -
endstop Z_MIN not work in firmware 0.92.3
by robmas59 ·#endif -
G31 state H
by Repetier ·#endif -
Add new Kinematic in Repetier Firmware
by Blitzliner ·#endif -
G29 Trouble 0.92.3
by Repetier ·#endif -
v092: "use_advance" in combination with "drive_system 2"
by Repetier ·#endif -
serial com error system io ports
by Weedz ·//select font size#define UI_FONT_6X10 //default font#ifdef UI_FONT_6X10#define UI_FONT_WIDTH 6#define UI_FONT_HEIGHT 10#define UI_FONT_SMALL_HEIGHT 7#define UI_FONT_DEFAULT repetier_6x10#define UI_FO -
Extruder motor won't go
by kreto ·#endif -
RADDS Board with Full Graphic Reprap Clone
by Repetier ·#endif -
"temp sensor defect" message with megatronics v3
by benzuria ·#endif -
Extruder temp issue
by Repetier ·#endif //TEMP_BED_PIN -
Mixing Extruder
by Repetier ·#endif -
Extruder temp issue
by NeoPolak ·#endif //TEMP_BED_PIN -
Start point
by Georg99 ·#endif -
Arduino IDE compilation error
by Repetier ·#endif