#define ALWAYS_CHECK_ENDSTOPS 0

#define X_ENABLE_ON 0

#define HOST_RESCUE 0   

#define MICROSTEP_MODES { 8,8,8,8,8 } // [1,2,4,8,16]

//#define MOTOR_CURRENT {135,135,135,135,135} // Values 0-255 (RAMBO 135 =

#define MOTOR_CURRENT_PERCENT { 55,55,55,55,55 }

// #define STEPPER_FREQUENCY 153000     // Maximum stepper frequency.

#define HOST_RESCUE 0

#define NUM_FANS 1

Probably so you are right, now I check the firmware and correct and test immediately. Do you know what the #define on configuration.h is?

#define Z_PROBE_TYPE 1          // 0 = no z probe, 1 = default z probe, 2 = Nozzle as probe

#define EXTRUDER_IS_Z_PROBE 1 --> so ist es eingestellt, verbaut ist ein kappazitiver Näherungsschalter mit diesen offsets, welche auch berücksichtigt werden:

#define EXTRUDER_IS_Z_PROBE 1

#define Z_PROBE_REPETITIONS 1

#define Z_PROBE_COATING 0

#define DISTORTION CORRECTION R from 100 to 90

So do I have to reduce these values? #define DISTORTION_XMIN 10 #define DISTORTION_YMIN 10 #define DISTORTION_XMAX 190 #define DISTORTION_YMAX 190 In this: #define DISTORTION_XMIN -90 #d

I can see gain but no bias. I still don't understand what I should put in #define TEMP_GAIN 0? 0 or 1?

#define Z_PROBE_SWITCHING_DISTANCE 5

In configure.h i edited #define TEMP_GAIN 20 (from 0). It is Ok?