okite
About
- Username
- okite
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
/* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of …
-
G32: 00:12:39.709 : g3200:12:40.260 : Z correction disabled00:12:40.260 : Info:Autoleveling disabled00:12:51.097 : Z-probe:0.550 X:0.00 Y:0.0000:12:52.198 : Z-probe:0.638 X:0.00 Y:60.0000:12:53.927 : Z-probe:0.664 X:0.00 Y:120.0000:12:56.567 : Z-pro…
-
I start thinking, that the board has some failure, or I am stupid... :-(
-
It works perfectly, but then, after Z homing, ext0 goes up several milimetres and M114 reports Z = 0 (but it is in fact several milimetres up... thus, it prints in this distance above the bed.
-
Thanks, I use DEV version. I will try.
-
yes, ALWAYS_CHECK_ENDSTOPS 0have z probe = z min pin now I wanna add Z_max, but not homing Z_max
-
So this method gives bad results - it is the same as it was - it prints cca 3mm above bed from the beginning... probably I have bad setup somewhere, I am desperate how to find... Do you think I could have bad steppers setup?Thanks.
-
Will try, thanks!
-
Hi,I used set it up this way - go manually down to cca 0.1 (thin paper), then trigger the probe and tighten probe screws. Then tune up Z-probe height value until the Z is OK (gap 0.1 mm). It worked with old printer, now prints cca 3mm above bed. Wh…
-
Thanks a lot, I will try dev version toady. Please, can you recommend the right height calculation method? I probably misunderstood. Thanks a lot.
-
Hi, I have similar problem with MPX.3... After using DEV version and selecting MPX3 board, heating does not function - looks like sensor error. Stabile firmware version functioned well, but I had problems with printing circle. Do you have sample con…