tim@aptico.de
About
- Username
- tim@aptico.de
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Ah ok - i did not realize that combining filament configurations within a single .ini is a wanted feature... anyway: i think the invisibility of this within the GUI is still problematic... it took me quite a long time to get to the root cause here…
-
same problem with repetierhost (win7;v2.0.1) + repetierserver (linux;latest) + rf1000! Manual control very risky (= nearly unusable)
-
Ok you are absolutely right! I was able to track down the problem towards a buggy filament-/extruder-profile that contains filament_diameter = 3,7 this one triggers the above behavior. The question that arises from this as it nearly drove me…
-
Versions: Slic3r: 1.3.0-dev, 1.2.9 (all version i tried) Repetierhost: 2.0.1
-
Repetier said: We are not the author of RF firmware, so can not say. They have apparently added this modification. So "doEmergencyStop(): block all (Z-Block)" is a Renkforce speciality and not contained in stock repetier firmware?