Trouble printing small details.

OGStyle · November 2015

I tried printing a google android an the antenna printed all messed up. I am also having this problem with the chimney on a 1 inch tall house that I printed. Is there any way to get these to print better?

Thanks

Repetier · November 2015

Small parts are extremely difficult, needs low speed and a good fan and clean extrusion.

OGStyle · November 2015

Is there a way to make the printer slow down when it gets to that part?

Repetier · November 2015

In slic3r filament->cooling you can set minimum layer time and minimum speed.

OGStyle · November 2015

Thanks. I'm new to the repetier firmware and slicer. I'm still learning.

Trouble printing small details.

Comments