Start print upon receipt of gcode option

cosmith71 · December 2020

I would like an option to have RS start printing immediately upon receipt of a gcode. With PrusaSlicer now supporting direct upload to RS, this would be very handy.

Thanks!

Repetier · December 2020

That is already possible - just put the gcode on the direct print upload button. I also have suggested that to the prusaslicer authors as "special" folder, but haven't seen them implementing this so far. Maybe you point them on this in this thread:
https://github.com/prusa3d/PrusaSlicer/issues/5083

that is where I explained how it can be easily done.

cosmith71 · December 2020

Thanks for your response. I opened a feature request for it.

Start print upon receipt of gcode option

Comments