There are gaps in the printed model layers

Comments

• Repetier

  April 2017

  There are no default settings it all depends on what you have, which nozzle size etc. Assuming printer is calibrated you may have to modufy flow multiplier for filament to extruder more if lines come out too thin, that is all.
• umitakin

  April 2017 edited April 2017

  Flow multiplier for filament ? Is it from memory or software?

  Extruder step :357 

  Filament flow rate from extruder is normal.

  Filament release rate is% 106
• umitakin

  April 2017

  Our questions seem very absurd to you. But I try to understand. Thank you for your interest.
• Repetier

  April 2017

  In slic3r it is in filament settings. You can also use flow multipler in host/server to test how it looks if flow is increased. Increasing it pushes mor efilament so it gets broader closing gaps. 

  
  

  You might also want to reduce extrusion width in slic3r settings. I have for my 0.5mm nozzle set extrusion with explicitly to 0.5 so it does not broaden by slic3r choice. But that means longe rprint times so personal liking.
• umitakin

  April 2017 edited April 2017

  https://drive.google.com/file/d/0B6Stm3Sp3RWdTXNoZFBCMFBmaEE/view?usp=sharing

  
  

  Https://drive.google.com/file/d/0B6Stm3Sp3RWdOWRlSjJYS0V5Mkk/view?usp=sharing
  

  
  

  Https://drive.google.com/file/d/0B6Stm3Sp3RWddThwN1NsWWtkQmM/view?usp=sharing
  

  
  

  Benim örnek çıktıım yazıcıdan çıktı. 
  

  I have to increase the number of layers of the base coat while printing a large pattern on the printer tray. I set all of the axes to a distance of 0.5 to 0.3. I think this is normal.
  
• umitakin

  April 2017

  My 3d Printer:https://drive.google.com/file/d/0B6Stm3Sp3RWdd18taXpSSG5OSFE/view?usp=sharing
• Repetier

  April 2017

  "increase the number of layers of the base coat" is nothing I can understand. 

  
  

  First layer is 0.3 for my delta, all following layers 0.2-0.1mm depending on quality I want. This is with 0.4mm nozzle.