› ›

Jmgerard

About

Username
Jmgerard
Joined
Visits
7
Last Active
Roles
Member

Comments

  • Hi all, I have the Ender 3 Max with 4.2.7 board. I am running Repetier Server on a PI. Are there any update/driver to connect to this printer. I tried seting up the printer in Repeater Server and it says that it is connected but I can't control my p…
    in Options for Ender 3 Max (Similar to Pro / v2) Comment by Jmgerard December 2021
  • I just installed Slic3r latest version for the Mac. Was using Simplify3D. I, too, See that the overall speed is grayed out and set to 80mm/s. This option is under the Advanced settings. I can set the "Max Volumetric Speed". Also under "Acceleration …
    in Slic3r perimeter speed settings grayed out Comment by Jmgerard October 2020
  • Repetier said: A slicer inside server is planned and will come with an update when available. Until then you should install a slicer on your pc and slice there and just upload the sliced gcode. My favourite free slicer is Prusa Slicer, but an…
    in which slicer to use Comment by Jmgerard October 2020
  • This gives me some information. My printer uses  the MKS Gen L v1.0 8 bit board. It is a Creality cr10 clone. It is the Tevo Tornado 2018 Gold edition printer.  Do you or any one know of any information on how to use the Arduino web interface. I hav…
    in Upload Firmware option Comment by Jmgerard October 2019
  • Thank you that it. I have repetier Server running n a Raspberry Pi3. Love it.
    in Dark mode Comment by Jmgerard October 2019