› ›

ajit_jain1

About

Username
ajit_jain1
Joined
Visits
27
Last Active
Roles
Member

Comments

  • Can you please help me where I should make the required change in the Configuration.h file  #define PDM_FOR_COOLER 0#define DECOUPLING_TEST_MAX_HOLD_VARIANCE 20#define DECOUPLING_TEST_MIN_TEMP_RISE 1#define KILL_IF_SENSOR_DEFECT 0#define RETRACT_ON…
    in Extruder motor won't go Comment by ajit_jain1 March 2015
  • Hi all, I receive this message as soon as I connect the printer. "extruder 0 : temp sensor defect""Error: printer set into dry mode until restart" After this the command M302 does not work i suppose? Thanks in advanceAjt
    in Extruder motor won't go Comment by ajit_jain1 March 2015
  • Hi all, i am also facing the same problem. Dry Run Deactivated in the host. The Extruder will not move. But I see that the motor is locked, meaning it has got the sufficient voltage and current but just that the signal is not being sent. Has anybody…
    in Extruder motor won't go Comment by ajit_jain1 March 2015