› ›

Govahnator

About

Username
Govahnator
Joined
Visits
0
Last Active
Roles
Member

Comments

  • To be honest , i think i am only triggering a bug. I use the exact same Gcode in slic3r(via repetier host) and simplify3d without problems. If i close repetier host every time after a print, the problem doesn't occur.
    in Problem every 3 prints Comment by Govahnator January 2017
  • you are right i am sorry, Yes i am still using marlin at the moment but will change to Repetier soon. The thing is this only happens with Cura engine.
    in Problem every 3 prints Comment by Govahnator January 2017