Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Bug Reports
Prints freeze
Unable to access eeprom configuration....
The estimated time in repetier shows up negative
Print Panel coordinates doubling when manual moving. Mac V 1.011
GUI coordinates not updating after G92 and M114 (V1.6.2)
Unable to open Printer properties
Printer pauses for several seconds when printing curves, leaving behind a zit.
No Extruder Output
Bed Height Map Crashes after few probes.
Crash when userBased set to fals
[Linux V1.5.6] Save to Server Bug
some minor bugs
original RAMPS-FD D10, D11 outputs problem
Can't recover from hanging printer
SD card removal under filament change
Crash editing Printer name in Repetier-Host 1.6.1
Zmax move back after homing not working.
Z Axis homing fails to come back down sometimes
Can't send G-code Repetier-Host Mac
Incorrect temps displayed in dual temp configurations
« Previous Page
Next Page »
Privacy Policy
|
About Us
