Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Repetier-Firmware
Help to upgrade Repetier firmware for Tronxy X3 with new table dimensions (320x320mm)
Dev2: "RUMBA32_F446VE" no found
DEV2: M9999 after fatal state not allowed
Dev2: G30 always homes first
DEV2: DIR signal at low speed
PT100 Amplifier Board
Button To inject Gcode
dev2: Problems with offset Values, Dual Extrusion & BLTouch
The Z axis go down after "Z home" in CNC mode.
Dev2: Cleanup of configuration.h
Homing confusing
M81 mit S1 funktioniert nicht
Cannot set firmware to control HEATER_2_PIN as extruder cooling
Dev2 - I can’t activate the Jam control
Limit switches occasionally ignored when homing
Rumba32: Servo position at start and after "auto-off"
Autotuned Extruder Consistently Under Temp
Squarish Circles
X/Y probe offset not used when bed leveling
Help with bltouch
« Previous Page
Next Page »
Privacy Policy
|
About Us
