Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Bug Reports
v0.92 problem with G1 and x-axis
Virtual Z home in development version
Motor after homing in Z going down
Bed correction problem on CoreXY
Compilation error with Arduino 1.6.9, FW 0.92.9, Due+RADDS, Delta Printer
delta printer stepper motor always run with same gear ratio (1/10 of the right one)
Due firmware won't compile out of the box with Arduino SAM board package 1.6.7
error compilation in eepron.cpp (error: expected primary-expression before ';' token)
compilation problem
Coordinates could go wrong if manually controlled
* DANGEROUS * Laser turns ON while homing
Skipping first 4 lines of print HELP
RAMPS + Full Graphic Controller: Missing entries unless using print cooling fan
Random firmware resets
Custom table R1 resistor value
Retraction / reverse extrusion not working
Z-lift on deltas (and retraction)
Mircostep mode change not applying
[0.92.8, Delta] G33 moves to forbidden x/y coordinates with high number of correction points
0.92.8 G31 state don't change
« Previous Page
Next Page »
Privacy Policy
|
About Us
