#3

Remko you are using the wrong baudrate or wrong port (if you have multiple ports). For that reason no communication occurs and nothing happens.

To get around that little problem, I purchased an 8x8" piece of thin glavanized steel sheet (Do Not Buy Stainless Steel! Most are alloy #304 (cheapest), which believe it or not, is non-magnetic a

Another Problem:

Manually Update Ch340G Drivers and choose this one: https://www.dropbox.com/s/py4r28eo49cgvnh/chg340-fake-driver.zip?dl=0

I baught it 15 days ago, My Heatbed springs and screws were missing.

Solution #3: Buy a RAMPS 1.4 and a mega2560 (So did I)

Hello, My name is Marcelo. I install

Make sure bed coating is set to 0your definition for z probe height is the same. The image just shows the point where it triggers. The fact that your probe does not touch bed makes no difference.

with #3 I could just write the gcode to execute whatever for #1 and #2

"If you are satisfied and if you have a z-max endstop you can also send a “G29 S2” to measure the print area height and store it in eeprom (S1 will only measure the height)."

But, even with this fix, upload hex still not doing the job.It now stops at "Uploading firmware binary ...". 

In my case connection works with 0.70.1 similar as with 0.65. Printing stops in about 30min - 2h after start. I have tried with 2 printers (Andciv CM3E 3D  motherboard). Log of both test prints/ prin…

You need a z probe

I have two equal printers with motherboard Andciv CM3E 3D. I had problems with connection also with server version 0.65 but after installing new Windows 7 computer I almost get rid of those problems.…

First, verify that your probe is working with a G31. Does it toggle correctly? If you have a mechanical normally closed probe like mine, then #define Z_PROBE_PULLUP needs to be set to 1 before G31 wi…

My print jobs do not stop but I get.: Warning: Missed line detected - correcting buffer usage.

I suppose I could post-process my gcode, and add in lots of G201 to make the extra motor keep up, but it seems like it would be easier to make it use the value for z height.

Hey,my new RepRap is up and running (more or less), I'm able to print (well, hot plastic is being spewed around my bed but it's a start!), problem is my Z axis moves very slowly. When I manually adju…

#define SDSUPPORT 0should be