BLTouch G30 works, homing is not?
When I run G30 P2 It correctly probes, does two attempts, and everything works fine. When I try and run G28 or home through TS it will it the probe, back away, hit the probe a second time, stop, then ram the bed up at homing speeds. Not sure why? I have tried adding delays, different Z homing rates (20mm/s, 5mm/s) all behave the same. G30 Probe works perfect so I don't think its a wiring or connection issue. I'm guessing some timing issue with the BLTouch as I do notice during a probe it quickly jumps back after hitting the probe. During homing its slower to jump back before hitting it the second time. I tried higher Z Feedrates with no luck. Any ideas? BLTouch v 3.1