is there away I can post pictures on here..
after slicing the image shows , but when you go to manual mode no image shows.
the show filament is enabled sometimes it will show a small bit of the print but when you zoom In the lines go very thin and it no longer updates
OK image 1 is the view as soon as the image starts to print , image 2 is when I select zoom extents , and the 3 image is viewd from front
Well after much looking around the repetier host software and comparing with a new install , I can not resolve this issue .
Any other ideas?
I have almost got it back .. thatnks for you help..
I just updated to the new release version and now this version keeps crashing ..
im using window 10 on a sony vaio with intel graphics card