RPi v0.92.2 not properly recovering/reconnecting after hard firmware halt/reset
Recently updated 2 out of 5 of my hub Pi's to 0.92.2, but had one throw a thermal runaway due to a fan issue (All machines are running Marlin 1.1.9). In previous versions, the firmware would automatically recover and reset the machine, but I noticed that the machine was halted.
I hard-reset the controller, and when it came back on, the hub did not automatically try to reconnect. It was still "green/active" in the interface, but the bed temperature was zeroed out and no data was being passed. I had to deactivate/reactivate printer for it to successfully reconnect.
Is this a new bug, intentional behavior change, or something wonky with my own setups? Normally i'd say it was this one hub, but I forced one into a firmware-halting error on a different installation/board, and it did the same thing.