Settings of REPETIER
Dear Friends
Thanks for your help! Now I have a new question:
When I connect the printer (Geeetech i3C) to the PC, I can let filament leak in hand mode at both nozzles. The filament, however, runs very thin.
When printing, just as little filament comes out of the nozzles. But that is not enough!
How or where can I increase the leaking amount of filament?
Thanks
klausi
Thanks for your help! Now I have a new question:
When I connect the printer (Geeetech i3C) to the PC, I can let filament leak in hand mode at both nozzles. The filament, however, runs very thin.
When printing, just as little filament comes out of the nozzles. But that is not enough!
How or where can I increase the leaking amount of filament?
Thanks
klausi
Comments
Firmware:
- Steps per mm for extruder
Server:
- Flow multiplier
Slicer:
- Flow multiplier
They all get multiplied but normally it is extruder steps per mm not set correct. All others start with reasonable values.