How to Create New Tabs
Hey! First post here, thanks ahead of time for your patience.
I'd like to code and add a new tab to my software. I'm using a BoXZY 3d printer which allows for quickly changing between 3d printing, laser engraving, and milling and I'd like to try adding my own tools to it. How should I go about this process, and are there any existing discussions on this topic? I'm not sure what the proper terminology for everything is yet, so I've probably missed posts on this.
Thanks for your help!
I'd like to code and add a new tab to my software. I'm using a BoXZY 3d printer which allows for quickly changing between 3d printing, laser engraving, and milling and I'd like to try adding my own tools to it. How should I go about this process, and are there any existing discussions on this topic? I'm not sure what the proper terminology for everything is yet, so I've probably missed posts on this.
Thanks for your help!
Comments
If I remember right you can already switch the modes in our firmware in setup.