Temperature Calibration Tower (which one)
I have been looking for a good temperature calibration tower and there are many many options..
The question is "Which one would be better to print for accurate results"?
I have seen several that are very tall and go from 210 down to 160 (which i would think would be reasonable for PLA)
Others suggest printing only a few layers
Some have thick walls with break away points (presumably to see how well each temp adheres) while others are simple squares with a single wall thickness.
Since this is still a learning project, i would like to get the best value for the filament. I tried to print one last night that did not turn out well, but i think it was in part due to printing supports for it as i could not get all of the support material out of it after printing.
The one i printed was from here.
https://www.thingiverse.com/thing:915435
thoughts.. Opinions...??
The question is "Which one would be better to print for accurate results"?
I have seen several that are very tall and go from 210 down to 160 (which i would think would be reasonable for PLA)
Others suggest printing only a few layers
Some have thick walls with break away points (presumably to see how well each temp adheres) while others are simple squares with a single wall thickness.
Since this is still a learning project, i would like to get the best value for the filament. I tried to print one last night that did not turn out well, but i think it was in part due to printing supports for it as i could not get all of the support material out of it after printing.
The one i printed was from here.
https://www.thingiverse.com/thing:915435
thoughts.. Opinions...??
Comments