Autobedlevelling with 0.92.9
I am kind of running into a tiny problem here. I am doing autoleveling with an inductive sensor through 3mm glass. I am doing a G32 s2 everytime before a print, because I have a removable glass plate with a fixed bed and I want to be sure that i get it correct everytime. No my problem is that I have changed the points the probe is probing. It probes with this sequence: Bottom left, Bottom righ, middle top of the bed and forms a triange. The examples on the Zprobing page show a different seuqence. Bottom left, Bottom right and Top left. Is this a problem?
I am asking because although it gets quite close to being perfect, whenever it moves to the right side of the glassbed, it raises the z axis for about 0.1mm. The prints still are ok, but it still bothers me not beiing perfect. I am seeing the leadscrew turning, although there isnt actually a need.
Is the way I have my probing points setup a problem, or does the firmware compute the plane either way?
Do I have to input a Gcode after g32 s2 to make it work better?