Good morning
V2 runs on RUMBA32 and communicates perfectly with Repetier-host. The printer works very well. My application communicates with V1, but fails with V2. I sniffed the data traffic on the com port with "Serial Port Monitor" and it is clear that Repetier-host sends 100 bytes with the value 0x00 and immediately after 1 byte with the value 0x0a, at this point V2 immediately replies with data.
I reproduced exactly the same data transmission with my application, but once I send 0x0a I get no response from V2.
is it a matter of timing between the 100 byte block and 0x0a?
Is it possible that the serial port must be opened with specific settings?
With "Serial Port Monitor" I see the data traffic but not the serial settings.
Thank you
