Start at layer feature

diamonddrake

I've had some issues where I ran out of filament or something similar and needed to "rewind" the print, or repetier crashed or the cat unplugged the usb cable. It would be great If you could take a currently loaded and sliced gcode file and have a start option that was "start at layer xxx" where you could select a layer and basically resume your print.

just a though. I've manually done it by editing the gcode, but It would be a very nice interface option.

Thanks.

Repetier

Difficult to do when making it easy enough and even then it will only work for some printers with zmax homing. I leave this until we have catched up with all upen work?

Currently it is quite easy in host to delete the old layers. You can jump directly to layer changes with the layer navigation below gcode.