>Randomly one or two of the printers will start the printer
What I mean here is that all the printers are on the same raspberry pi. The failure is random. Sometimes 1 or 2 of the printers will present these symptoms while all the others are ok.
Here is a printer log from a failed print:
https://pastebin.com/kfQ1ETVk<br/><br/>In this specific print the following happened:
The print was started via Repetier-Server Monitor / Repetier Server
The printer with Repetier-Firmware started to heat normally
After heating, it starting the normal homing procedure
After that, it immediately went all the way to the X end stop and the motor continue to run despite being at the max X position (it was jammed and pushing to the far end)
It extruded normal amounts of filament but the X was stuck not moving and thus it created a giant blob of filament
The display showed normal output as if the printer thought it was printing
Inside Repetier-Server in the "Move" tab I could see the visualization of that print but it was happening VERY fast as if it was at 1000x speed
I eventually hit the hard stop on the printer which is the Reset at the end of the log.
