Position is not relevant. When 65mm right to nozzle it means you need to be at x 65 to be able to measure or you crash in x end stop, which is what the error says. So change points for measurement so position can be reached with active z probe. So x min at least 65 and y min at least 32.
Does homing z go until bed level or stop early? If it goes to bed level and back up it can also be
#define ENDSTOP_Z_BACK_ON_HOME 0.0
when it is 150 it will go up after z end stop by that distance and call it z=0.
G1 S1
just allows negative z, you still need to send moves to that e.g.
G1 Z-50 F1200
