MikeCL So I have a He3d K280 printer and it raises all the way to the end stops and then it should lower to the min Z position however it stops about 20 mm too short and I can’t make it lower anymore..how can I fix this?
Repetier So you are homing to z max with end position at bottom? In this case z length determines where firmware thinks z=0 is. So if it stops too high, z length is too low.
MikeCL On the K280 printer the Z end stops are at the top.. that is fine then after the end stops are triggered it starts to lower until about 20 mm from the hot bed and I can’t get it to go lower.
Repetier Multiple lines that set homing behaviour and dimensions. If in doubt post the top part of the config file (not the big comment at the end). The z length can be changed in eeprom editor of your host software.
