G02 and G03 code issue

bpetrus

Dear Experts!

My 3D printer not interpreting this code:

G03 X99.310635 Y20.941124 Z-0.125000 I-5.784536 J6.163855
or

G02 X89.944938 Y25.238500 Z-0.125000 I11.597644 J-10.953337

This code was generated by the inkscape laser tool.

The 3D printer does not execute any similar line.

Why?

Repetier

Make sure in config tool->Features to have

Enable arc support (G2/G3)

enabled or you won't have these commands.

bpetrus

Ok. Thank you...
But, where to find this options?

bpetrus

Well, meanwhile I found it:
Enable arc support (G2/G3): is checked.

Is the G02 format good, or G2?

bpetrus

I found in the configurator, but don't found in the configure.h.

This is it?: #define ARC_SUPPORT 1

Repetier

Yes
G02 X89.944938 Y25.238500 Z-0.125000 I11.597644 J-10.953337

is correct format also I normally just write G2. Problem might be negative Z value. Normally you can not move below z=0 so that would cause a illegal position and be ignored. Except if you moved up after homing and used G92 Z0 to mark that position zero. Then you can go as low as Z when sending G92.

bpetrus

Wery well!

If I delete the negative Z data then the 3D printer is work.

Thank you your advice!