Sungod3k Hi,I recently switched to repetier and now Im looking into some of the new features. Something I always wanted to have is the "extruder cooler pin" and I activated it in configuration.h and set it to digital pin 0. I also have one of these mosfet controllers http://www.thingiverse.com/thing:22202. </div><div><br/></div><div>However in pins.h I cant find the line that defines pin0, does someone know the #define aux-1 syntax here?Cheers
Repetier If you know the arduino pin number just write the number - no symbolic name needed. Arduino pins 0 and 1 are rx and tx for serial communication, so I guess that is not the best choice for a pin.
Sungod3k In the mean time I just went for it and treated digital pin 0 as already activated. I have the mosfet hooked up to 12V and the signal wire to pin 0. The fan is still always on no matter what temp I put in the firmware.
Repetier I don't even know your board, how could I say. Any free pin is fine. 0 and 1 ore just not free as serial uses them.
