3dprintfreak
<div><div>I'm
running a large delta 3d printer with repetier firmware. The problem
that is pissing me off is that the speed of the carriages are too low
;like an old lady that is walking in a football field.I mean when I command G1 Z10 for example the carriages move with a super low speed.I
checked everything but i couldn't find the problem. Here are the
specifics and the current settting of the printer:**Electronics : Arduino
due + RADDSLeadshine 42cmo6 ,6kg,2.5 A per phase stepper motors for x,y and z axesTOSHIBA ''TB67S109'' stepper drivers(0.1 resistance,1/16 mic stepping)*
*Vref of drivers : 0.7 v (when I increase this to 1 volt a wierd sound
come from steppers and the carriages won't move)* *number of pully teeth
:20* ****belt pitch : 2 *
*steps per rev : 200 *
micro stepping :1/16*** ****and steps
per mm :80 *
*Max. travel speed : 300 for X,Y,Z *
Homing speed :100 for X,Y,Z***
****Travel acceleration : 3000 for X,Y,Z *
Print acceleration : 1000 for
X,Y,Z**PS: I'm currently calibrating the printer and haven't print anything yet.Thanks in advance.</div></div>
