Cannot run auto leveling then distortion correction

Jonathan9573

So what’s happening is if I run auto leveling it measures as planned and inserts z height as 284.387, then if I try and run distortion correction it give error of unreachable cycle probing of 4.00056, 5.0458 or something like that. Can’t remember the exact error wording.
Also if I try to run auto leveling a second time it gives the same error message unless I change zheight back to the original 290 before I ran auto leveling the first time.

Repetier

Distortion correction has it's own set of coordinates compiled it. These must be reachable with activated probe. Sounds like that does not fit with given coordinates. Also use a start point where you can activate z probe without moving into invalid positions.

Jonathan9573

So I didn’t realize that there were different probe points for distortion correction so I changed those and still have the same issue. I changed move back on home on x and y from 5 to 2 and the error dropped the location from xy coordinates 4.999, 5.000 to 1.999 and 2. If that helps. My probe point for leveling are x 30 and y 35. I can send my eeprom later when I get home from work.

Repetier

1.999 or 2.000 does not differ. That look sjust like rounding errors from step to real conversion and can be ignored.
Test point 30 / 35 means offset must be <= 30 / 35 if extruder 0 has offset 0 / 0. Note that some offsets are in steps not mm.