<div>
<div>
<a rel="nofollow" target="_blank" href="https://www.youtube.com/channel/UCy0N17RxdwdPh1ANJ9sWqSA" title="Link: https://www.youtube.com/channel/UCy0N17RxdwdPh1ANJ9sWqSA">
Ron Rockwell
</a>
<a rel="nofollow" target="_blank" href="https://www.youtube.com/watch?v=HDmWuSSWgVI&lc=UgxMhvlN3i1U2msoc4l4AaABAg">1 second ago</a>
</div>
</div>
Hi, I know that this is very old, but I recently received one of these printers. It was given to me because the previous owner replaced it after the hot end went bad. I have purchased an E3D hot end as a replacement. The printer already has Repetier 0.92 installed.
I wanted to follow the videos that have been posted, but they stress that I must first level the bed and make some changes to the Repetier software. Trouble is that my printer does not have a working hot end. Therefore I can not get past the heating stages to proceed. Any advice on how I can move forward with the hot end install? I certainly don't want to crash the new E3D.
